Arts & Entertainments

Bottega Veneta inspired: 5 min, no pliers knot bracelet

A person holding a tattoo

I’m all about easy, fuss-free and quick DIYs so here’s another bracelet tutorial that requires no pliers, just glue!

What you need:

– 2 lengths of cord, 1.5 to 2 times the circumference of your wrist

– a pair of bails, with a clasp and ending chain attached

– glue: I used E6000 but keep in mind its longer drying time

Step 1: knot it

Make sure the 2 cords start flush with each other and are placed flat before tying a knot in the middle.  (Make a big loop with the cords then insert the 2 ends through and tighten the knot)

Step 2: snip it

Ensure the knot lies in the middle of your wrist. If the cord is too long, snip off the excess.

Step 3: glue it

Squeeze a generous amount of E6000 into the bail then insert the 2 cords of 1 end in. Hold for a minute then leave to dry. After about an hour, repeat with the other side.

Lester Bell

Lester Bell writes on wellbeing, habit and slow living, interested less in quick fixes than in what actually holds up over time.